2. Adjustable Maximum Temperature Setting
To set the maximum temperature ensure that an adequate supply of hot water
is available at a temperature at least 12°C in excess of that required from the
appliance, and the temperature control knob is set to the full hot position. Turn
the flow control knob fully anti-clockwise then check the temperature at the
discharge point (allow sufficient time for hot water to reach the hot inlet of the
appliance).
If the temperature is correct, turn the flow control knob fully clockwise to the off
position as no further adjustment is necessary.
If the maximum temperature achieved at the discharge point is unsatisfactory
then adjust the maximum temperature as follows:
Temperature
knob
Indicator
trim
Flow knob
2.1
Turn the flow control fully
on.
2.2.
Turn the temperature lever
anti-clockwise to full hot,
the lever will be against the
left hand stop of the cover
insert (3 o'clock position).
2.3.
Use the push-fit release
tool to lever off the flow
2.4.
Pull off the indicator trim.
23