Usb Fob Interface - FlowLine EchoWave LG11 Series Manual

Configuration
®
USB Fob Interface: EchoWave
interface called a Fob. Before plugging your Fob into your computer's USB
®
installed WebCal (version 6.5 or greater) on your computer.
Connect the red, green, white and black terminals on the Fob to the corresponding terminals within the
®
EchoWave . Tighten the screws on the terminals and plug your Fob into the USB
WIRING IS IDENTICAL FOR ALL SERIES OF ECHOWAVE

The maximum cable distance between the computer and EchoWave
configuring the EchoWave

Once EchoWave
to prevent a short of the configuration circuit

Note: When using the Fob, do not add VDC power. The Fob, when connected to the computer, will provide
the required power to the EchoWave
* For complete information on the WebCal
manual located at flowline.com/webcal-software.
| 26
®
communicates with WebCal
®
.
®
is configured and prior to installation, disconnect all wires from the center two terminals
®
.
®
(version 6.5 or greater) through a USB
®
®
(version 6.5 or greater) software, please refer to the WebCal
®
port, be sure that you have
®
port of your computer.
® is 15'. This only applies when
Section Five
®
®
MN300840 REV A5