Usb Fob Interface - FlowLine EchoWave LG10 Series Manual

Configuration
®
USB FOB INTERFACE
®
EchoWave communicates with WebCal
Before plugging your Fob into your computer's USB
6.5 or greater) on your computer.
Connect the red, green, white and black terminals on the Fob to the corresponding terminals within the
®
EchoWave . Tighten the screws on the terminals and plug your Fob into the USB
WIRING IS IDENTICAL FOR ALL SERIES OF ECHOWAVE

The maximum cable distance between the computer and EchoWave
configuring the EchoWave

Once EchoWave
to prevent a short of the configuration circuit

Note: When using the Fob, do not add VDC power. The Fob, when connected to the computer, will provide
the required power to the EchoWave
* For complete information on the WebCal
manual located at flowline.com/webcal-software.
MN300840 REV A8
®
(version 6.5 or greater) through a USB
®
.
®
is configured and prior to installation, disconnect all wires from the center two terminals
®
.
®
port, be sure that you have installed WebCal
®
®
(version 6.5 or greater) software, please refer to the WebCal
®
interface called a Fob.
®
port of your computer.
®
is 15'. This only applies when
Section Five
®
(version
®
27 |