Pipe Mounting; Panel Mounting - ProMinent DULCOMETER DMT Series Operating Instructions Manual

Fig. 6
4.2.2
See 4.2.1 Wall mounting
4.2.3
Connect the cable from the back through the cut-out in the control panel:
ProMinent ®
IMPORTANT
Check that the seal is located correctly. IP 65 is achieved only
when assembly has been carried out correctly.
(If necessary pull the front section forward in order to reduce
the stress on the seal.)
Tighten the housing screws finger tight.
4

Pipe mounting

Panel mounting

NOTE
The cable must be laid in cable ducting on site to minimise
stresses.
Follow the steps given in 4.2.4 Connecting coaxial cable and 4.2.5
Connecting terminals.
Assembly and installation
1
2
3
3465_3
Page 15