Float Level Inspection - Honda Activa SCV110 Service Manual Digest

Install the following:
— Throttle stop screw/spring
— Slow jet
— Needle jet holder
— Needle jet
— Main jet
Handle all jets with care. They can easily be scored or
scratched.
Install the air screw/spring/washer/o-ring and return it to
its original position as noted during removal.
Perform the air screw adjustment procedure if a new air
screw is installed (page 5-10).
Install the float and float valve in the carburetor body, then
install the float pin through the body and float.

FLOAT LEVEL INSPECTION

With the float valve seated and the float arm just touching
the valve, measure the float level with the special tool as
shown.
FLOAT LEVEL: 11.7 ± 0.5 mm (0.46 ± 0.02 in)
TOOL:
CARBURETOR FLOAT LEVEL GAUGE
The float cannot be adjusted.
Replace the float assembly if it the float level is out of
specification.
Install a new O-ring into the float chamber groove.
WASHER
AIR
SCREW
O-RING
070MJ – 001-I110
FUEL SYSTEM
O-RING NEEDLE JET
SPRING
THROTTLE
STOP SCREW
FLOAT PIN
FLOAT VALVE
FLOAT
FLOAT LEVEL GAUGE
O-RING
NEEDLE
JET
HOLDER
MAIN
JET
SLOW
JET
5-7