Tool; Connector; Cable Connection To Input/Output Connector - Mitsubishi FX3G Series User Manual

FX /FX /FX PLC User's Manual - Positioning Control Edition
3G 3U 3UC
Built-in Positioning Functions
3.2.3

Tool

• To tighten the terminals, use a purchased small-sized screwdriver whose tip is straight and is not widened
as shown in the right figure.
Note:
If the diameter of screwdriver grip is too small, tightening torque will not
be able to be achieved. Use the following recommended screwdriver or
an appropriate replacement (grip diameter: approximately 25mm).
Manufacturer
Phoenix Contact
3.3

Connector

Connectors conforming to the requirements of the MIL C-83503 are used for the FX
along with some types of FX
3.3.1

Cable Connection To Input/Output Connector

Prepare the input/output cables while referring to the next Subsection.
Example : FX
3UC
Series input/output extension blocks.
2NC
-32MT/D Main unit
3 Connection of Input/Output Lines and Tightening
Model
SZS 0.4×2.5
Input: X Output: Y
Input
X0 X10
X1 X11
X2 X12
X3 X13
X4 X14
X5 X15
X6 X16
X7 X17
COM COM
*1
*1: "•" means that the terminal is not used.
3.3 Connector
With
straight tip
0.4mm 2.5mm
(0.02") (0.1")
Series main unit
3UC
Output
Y0 Y10
Y1 Y11
Y2 Y12
Y3 Y13
Y4 Y14
Y5 Y15
Y6 Y16
Y7 Y17
COM1 COM1
*1 *1 *1
B - 33
A
B
Apx.