Fx 3Uc Series Main Unit (Transistor Output - Mitsubishi FX3G Series User Manual

FX /FX /FX PLC User's Manual - Positioning Control Edition
3G 3U 3UC
Built-in Positioning Functions
2.5.2 FX Series main unit (Transistor Output)
3UC
This section describes the transistor output specifications of the FX
simultaneous turning-on rate is restricted for the output extension units and the main unit. For details on this
restriction, refer to the following manual:
For MELSERVO Series amplifiers, use a sink input/sink output type PLC.
External voltage
Resistance load
Maximum
load
Inductive load
Open-circuit leakage current
ON voltage
FX
3UC
FX
3UC
Response
FX
time 3UC
FX
3UC
DSS
Circuit insulation
Indication of output motion
*1. The FX
3UC
Pulse output terminals Y000, Y001, and Y002 are high-speed response output terminals.
To use the positioning instruction, adjust the load current of the NPN open collector to 10 to 100 mA (5 to 24V DC).
Item
Operation voltage range
Operation current range
Output frequency
1. Sink internal output circuit
FX - MT/D
3UC
FX -32MT-LT(-2)
3UC
Main unit
*2. To ground the unit, refer to the servo amplifier (drive unit) manual. If the grounding method is not
specified, carry out class-D grounding.
B - 24
Item
-32MT-LT OFF→ON
-32MT-LT-2 ON→OFF
- MT/D
OFF→ON
- MT/
ON→OFF
-32MT-LT(-2) uses the display module for monitoring.
Description
5 to 24V DC
10mA to 100mA
100 kHz or less
Y0
Y4
COM1
3UC
→ Refer to the FX
Transistor output specifications
All outputs 5 to 30V DC
Y000 to Y003 0.3 A/point
Y004 or more 0.1A/1point
7.2W/1point
Y000 to Y003
(24V DC)
2.4W/1point
Y004 or more
(24V DC)
All outputs 0.1 mA or less at 30V DC
All outputs 1.5V
Y000 to Y003 5 µs or less at 10 mA or more (5 to 24V DC)
Y004 to Y017 0.2 ms or less at 100 mA (at 24V DC)
Y000 to Y002 5 µs or less at 10 mA or more (5 to 24V DC)
Y003 or more 0.2 ms or less at 100 mA (at 24V DC)
All outputs Photocoupler insulation
-
LED is lit when the photocoupler is driven.
5 to 24V DC
Pulse train signal
Direction signal
Grounding
2 Specifications
2.5 Output Specifications
Series main unit. Note that the
Hardware Edition.
3UC
The total load current of the common
items (16 points) should be 1.6 A or
less.
The total load of the common items
(16 points) should be 38.4 W or less at
24V DC.
Servo amplifier
(Drive unit)
*2
*1