Quick Menu; Main Menu - Danfoss FC 51 Series Programming Manual

Programming

3.3 Quick Menu

The Quick Menu gives easy access to the most frequently
used parameters.
1. To enter the Quick Menu, press [Menu] key until
3 3
indicator in display is placed above Quick Menu.
2.
Press [
press [OK].
3.
Press [
in the Quick Menu.
4. Press [OK] to select a parameter.
5.
Press [
setting.
6. Press [OK] to accept the change.
7. To exit, press either [Back] twice to enter Status,
or press [Menu] once to enter Main Menu.
Illustration 3.9 Indicating Quick Menu Mode

3.4 Main Menu

The Main Menu gives access to all parameters.
1. To enter the Main Menu, press [Menu] key until
indicator in display is placed above Main Menu.
2.
Press [
groups.
3. Press [OK] to select a parameter group.
4.
Press [
in the specific group.
5. Press [OK] to select the parameter.
6.
Press [
7. Press [OK] to accept the value.
8. To exit, press either [Back] twice to enter Quick
Menu, or press [Menu] once to enter Status.
Illustration 3.10 Indicating Main Menu Mode
10
VLT
▲ ▼
] [ ] to select either QM1 or QM2, then
▲ ▼
] [ ] to browse through the parameters
▲ ▼
] [ ] to change the value of a parameter
▲ ▼
] [ ] to browse through the parameter
▲ ▼
] [ ] to browse through the parameters
▲ ▼
] [ ] to set/change the parameter value.
MG02C602 - VLT
®
Micro Drive FC 51 Programming Guide
®
is a registered Danfoss trademark