wtw inoLab Multi 9620 IDS Operating Manual page 106

Settings
Menu item
System / General / Temperature
unit
System / General / Barometric
pressure unit
System / General / Stability control
System / Interface / Baud rate
System / Interface / Output format
System / Interface / Decimal sepa-
rator
System / Interface / Output header
System / Interface / Extended Oxi
output
System / Clock function
System / Service information
System / Reset
106
Setting
°C
°F
mbar
mmHg
inHg
on
off
1200, 2400, 4800,
9600, 19200
ASCII
CSV
Dot (xx.x)
Comma (xx,x)
Date format
Datum
Time
-
inoLab
Explanation
Temperature unit,
degrees Celsius or degrees Fahren-
heit.
All temperature values are displayed
with the selected unit.
Air pressure unit
Switches on or off the automatic stabil-
ity control during measurement (see
section 11.7.3 A
UTOMATIC
, page 107 )
CONTROL
Baud rate of the USB-B interface (USB
Device)
Output format for data transmission
For details, see section 13 T
, page 118
TING DATA
Decimal separator
Output of a header for Output format:
CSV
The measured values for the parame-
ters concentration (mg/l ) and satura-
tion (%) are output together.
The function is active if the following
requirements are met:
 a D.O. sensor is connected
 The D.O. sensor displays the
parameter concentration (mg/l) or
saturation (%)
 the Output format CSV is set
Settings of time and date.
For details, see section 4.5.5 E
2 : S
ON NAVIGATION ETTING THE DATE
, page 25
AND TIME
Hardware version and software ver-
sion of the meter are displayed.
Resets the system settings to the
default values.
For details, see section 11.8.2 R
TING THE SYSTEM SETTINGS
ba77173e04
®
Multi 9620 IDS
S
TABILITY
-
RANSMIT
XAMPLE
-
ESET
, page 111
12/2017