wtw inoLab Multi 9620 IDS Operating Manual page 94

Settings
Menu item
Alternative tempera-
ture
Man. temperature
pH resolution
mV resolution
Limit monitoring
Limit monitoring/
pH monitoring
Limit monitoring/
TP monitoring
Limit monitoring/
pH monitoring/on/
pH upper limit
Limit monitoring/
pH monitoring/on/
pH lower limit
Limit monitoring/
TP monitoring/on/
TP upper limit
94
Possible Explanation
setting
on Takes over the temperature value from an IDS sensor.
off
This menu item is only available if an IDS adapter and an
IDS sensor with integrated temperature sensor are con-
nected.
-25 ... +25 ... Entry of the manually determined temperature.
+130 °C This menu item is only available if an IDS adapter is con-
nected.
0.001 Resolution of the pH display
0.01
0.1
0.1 Resolution of the mV display
1
With the Limit monitoring function you define the measured
values whose exceeding is signaled. An acoustic signal
sounds, and at the same time a message is output to the
USB interface.
You can switch on or off the acoustic signal in the System
menu (see section 11.7.1 S
on Switch on or off the limit signaling device for the pH value.
off
on Switch on or off the limit signaling device for the temperature
off value.
-2 ... 20 Upper range limit. If it is exceeded, a message is output to
the interface USB-B (USB Device, e.g. PC) or USB-A (USB
Host, e.g. USB printer).
This menu item is only visible when the pH monitoring set-
ting is active.
-2 ... 20 Lower range limit. If it is exceeded, a message is output to
the interface USB-B (USB Device, e.g. PC) or USB-A (USB
Host, e.g. USB printer).
This menu item is only visible when the pH monitoring set-
ting is active.
-5 ... Upper range limit. If it is exceeded, a message is output to
+105 °C the interface USB-B (USB Device, e.g. PC) or USB-A (USB
Host, e.g. USB printer).
This menu item is only visible when the TP monitoring set-
ting is active.
®
inoLab Multi 9620 IDS
, page 105).
YSTEM
ba77173e04 12/2017