Service and maintenance
6.3 Maintenance and repair work
6.3
Maintenance and repair work
6.3.1
Maintenance
The device is maintenance-free. However, a periodic inspection according to pertinent
directives and regulations must be carried out.
An inspection can include check of:
● Ambient conditions
● Seal integrity of the cable entries and cover screws
● Reliability of power supply, lightning protection, and grounds
6.3.2
Service and maintenance information
Service and maintenance information is information about the condition of the device used
for diagnostics and service purposes. Refer to the FS230 Service manual for details.
6.4
Return procedures
6.4.1
Original packaging
If the original packaging is no longer available, ensure that all shipments are properly
packaged to provide sufficient protection during transport. Siemens cannot assume liability
for any costs associated with transportation damages.
Insufficient protection during storage
The packaging only provides limited protection against moisture and infiltration.
• Provide additional packaging as necessary.
For special conditions for storage and transportation of the device contact Purpose of this
documentation (Page 7).
6.4.2
Return procedure
Enclose the bill of lading, return document and decontamination certificate in a clear plastic
pouch and attach it firmly to the outside of the packaging.
78
CAUTION
FSS200 clamp-on sensors
Installation Manual, 08/2017, A5E36255466-AC