Parameter Settings; Parameter Settings Of Cc-Link Safety - Mitsubishi Electric MELSEC-QS Series Safety Application Manual

6
SAFETY APPLICATION CONFIGURATION EXAMPLE (USING
SEVERAL SAFETY PROGRAMMABLE CONTROLLERS)
6.3

Parameter Settings

This section describes parameter setting examples.
For descriptions and setting ranges of the parameters, refer to the following.
6.3.1
(1) Network parameter settings
Start I/O No.
Operational settings
Mode
Transmission speed
Safety refresh monitoring time
Safety data monitoring time
Link ID
All connect count
Remote input (RX)
Remote output (RY)
Remote register (RWr)
Remote register (RWw)
Special relay (SB)
Special register (SW)
Retry count
Automatic reconnection station count
Scan mode setting
Station information
setting
Remote device station initial setting
6
- 4 6.3 Parameter Settings

6.3.1 Parameter settings of CC-Link Safety

CC-Link Safety System Master Module User's Manual
MELSEC-QS CC-Link IE Field Network Master/Local Module User's Manual
Parameter settings of CC-Link Safety
Set the following values to the network parameters for safety master stations of safety
programmable controllers (1) to (3) on CC-Link Safety.
Table 6.2 Setting example of network parameters
Module
Case of CPU STOP
*1
setting
Station information
Safety remote station
settings
* 1: Fixed at "Clears compulsorily" when the safety CPU operation mode is set to SAFETY MODE.
POINT
POINT
Set the link ID and transmission speed values of the network parameter and those
of the switches of the connected CC-Link Safety remote I/O module so that they
may be the same.
Safety programmable controllers (1) to (3)
CC master (1)
0000
H
Clears compulsorily
Safety remote net (Ver. 1 mode)
2.5Mbps
50ms
80ms
0
2
X100
Y100
–
–
SB0
SW0
3
1
Synchronous
Section 6.3.1 (2)
Section 6.4.1 (4)
None