Safety Instructions - Kontron CP6924-1 User Manual

Note...
This symbol and title emphasize aspects the reader should read through carefully for his
or her own advantage.
CE Conformity
This symbol indicates that the product described in this manual is in compliance
with all applied CE standards. Please refer also to the section „Regulatory cpmpli-
ance Statements" in this manual.

Safety Instructions

Your new Kontron product was developed and tested carefully to provide all features necessary to ensure its compliance
with electrical safety requirements. It was also designed for a long fault-free life. However, the life expectancy of your
product can be drastically reduced by improper treatment during unpacking and installation. Therefore, in the interest of
your own safety and of the correct operation of your new Kontron product, you are requested to conform with the following
guidelines.
Temperature and High Voltage Safety Instructions
All operations on this device must be carried out by sufficiently skilled per-
sonnel only.
Be careful, this device will heat up during operation, and if touched
may cause burns. The temperature of the product housing may reach up
to approximately 50°C. Allow for sufficient cool down before handling
after power is turned off.
Electric Shock
Before installing your new Kontron product into a system always
ensure that your mains power is switched off. This applies also to the
installation of piggybacks.
Serious electrical shock hazards can exist during all installation,
repair and maintenance operations with this product. Therefore,
always unplug the power cable and any other cables which provide
external voltages before performing work.
9
WARNING
CP6924-1 User Guide
www.kontron.com