Table of Contents
Advertisement
2.3
Standard Removal Procedures
To remove the board proceed as follows:
1. Ensure that the safety requirements indicated in chapter Safety Requirements are observed.
Care must be taken when applying the procedures below to ensure that nei-
ther the CP6924 nor other system boards are physically damaged by the
application of these procedures.
2. Ensure that no power is applied to the system before proceeding.
3. Disconnect any interfacing cables that may be connected to the board.
4. Unscrew the front panel retaining screws.
Due care should be exercised when handling the board due to the fact that
the heat sink can get very hot. Do not touch the heat sink when changing the
board.
5. Disengage the board from the backplane by first unlocking the board ejection handles and then by pressing the han-
dles as required until the board is disengaged.
6. After disengaging the board from the backplane, pull the board out of the slot.
7.
Dispose of the board as required.
2.4
Software Installation
The CP6924 comes as a pre-installed system with all necessary OS, filesystem, drivers and applications factory-installed
with default configurations.
Updating the Software with new operating system or applications or new versions is provided by a dedicated update mech-
anism, which is described in Chapter 4.
21
WARNING
WARNING
CP6924-1 User Guide
www.kontron.com
Advertisement
Table of Contents
