Table of Contents
Advertisement
1.2
Technical Specification
1.2.1
Power Requirements
Operating voltages are 5.0 Volt and 3.3 Volt.
The maximum power consumption is less than 50W.
1.2.2
Mechanics
Compliant to PICMG® 2.0 6U/4HP (233.35 mm x 160 mm).
•
Weight:
•
CP6924-1-RA-OC and CP6924-1-SA-OC-V: 720g
•
CP6024-1-RC: 1170g
The CP6924-1-RA-OC and CP6924-1-SA-OC-V use a front panel. The CP6924-1-RC does not need a front panel.
1.2.3
Temperature
Compliant to IEC 60068-2-1 and IEC 60068-2-2.
•
CP6924-1-RA-OC
•
Operation from -40° C to +85° C inlet air temperature
•
CP6924-1-RC
•
Operation from -40° C to +85° C wedge lock temperature
•
CP6924-1-SA-OC-V
•
Operation from 0° C to +60° C inlet air temperature
Required average inlet airflow should be around 400LFM (2 m/s) for the maximum cooling. Other thermal limitations may
apply and are the responsibility of the system integrator.
Storage temperature range is -50° C to +105° C for all variants.
1.2.4
Humidity
The boards are designed to meet the standard IEC 60068-2-78 operating 93% at 40°C (non-condensing).
1.2.5
Altitude
The boards are designed to meet the following requirements:
•
Operating: 4000m (13123 ft). Check for onboard peripherals if applicable
•
Non-Operating: 15000 m (49212 ft)
1.2.6
Vibration
The CP6924-1-SA-OC-V board is designed to meet the requirements according ANSI/Vita 47 V2:
Class V2 plug-in units shall withstand vibration as defined below for 1 hour per axis:
•
5 Hz to 100 Hz PSD increasing at 3 dB/octave
•
100 Hz to 1000 Hz PSD = 0.04 g2/Hz
•
1000 Hz to 2000 Hz PSD decreasing at 6 dB/octave
The CP6924-1-RA-OC board is designed to meet the requirements according EN60068-2-6:
•
10 Hz to 300 Hz, 2g acceleration
•
1 octave/min
•
10 cycles/axis, 3 directions [x, y, z]
14
CP6924-1 User Guide
www.kontron.com
Advertisement
Table of Contents
