Software Description; Supported Rfcs; Management - Kontron CP6924-1 User Manual

Standard fabric 6u compactpci gigabit ethernet switch
Table of Contents

Advertisement

4

Software Description

Software on the CP6924-1 includes the following parts:
Bootloader
initrd (including rootFS, kernel)
Application software (FASTPATH switching SW)
IPMI Firmware
The Software accomplishes operation of the switching hardware and is therefore also referenced as firmware. It is pre-
installed on the system and can only be updated by a dedicated update procedure. This manual describes bootloader, Linux
rootfs/kernel and IPMI firmware, last chapter introduces the update procedures.
For additional information of system configuration using CLI commands refer to documentation "CP6924-1 CLI Reference
Manual".
4.1

Supported RFCs

The Software supports the following standards and RFCs.
4.1.1

Management

RFC 854 - Telnet
RFC 855 - Telnet Option
RFC 1155 - SMI v1
RFC 1157 - SNMP
RFC 1212 - Concise MIB Definitions
RFC 1867 - HTML/2.0 forms with file upload extensions
RFC 1901 - Community based SNMP v2
RFC 1908 - Coexistence between SNMP v1 and SNMP v2
RFC 2068 - HTTP/1.1 protocol as updated by draft-ietf-http-v11-spec-rev-03
RFC 2271 - SNMP Framework MIB
RFC 2295 - Transparent Content Negotiation
RFC 2296 - Remote Variant Selection; RSVA/1.0 State Management "cookies"
RFC 2576 - Coexistence between SNMP v1,v2 & v3
RFC 2578 - SMI v2
RFC 2579 - Textual Conventions for SMI v2
RFC 2580 - Conformance statements for SMI v2
RFC 3410 - Introduction and Applicability Statements for Internet Standard Management Framework
RFC 3411 - An Architecture for Describing SNMP Management Frameworks
39
CP6924-1 User Guide
www.kontron.com

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cp6924-1-ra-ocCp6924-1-rcCp6924-1-sa-oc-vCp6924

Table of Contents