Epson SC-B7000 Series Service Manual page 23

SC-F7000 Serie/SC-B7000 Series
Menu
1 to 30 (Media
Customize
setting bank)
Media Setup
Settings
Print Media List
PRODUCT DESCRIPTION
Menu Item/Setting Values (shaded one is the default)
Drying Time Per
Drying
Pass
Media Suction 0 to 10
Data Width
Head Movement
Printer Full Width
Off
Multi-Strike
Printing
2 to 8
Printable Side Out
Roll Type
Printable Side In
Periodically
Every Page
Tension
Measurement
Off
Media Tension 0 to 40
Feed Speed 1 to 2
Print
Table 1-15. Setup Menu
Sets a time period to pause the Print Head movement for drying the ink
between 0.0 to 10.0 seconds. Depending on the media type and density,
0 to 10 sec
drying ink may take longer. When leaked ink or ink smear appears on the
printed result, set the drying time longer.
Set it to a suction level appropriate for the used media.
Choose the range in which the print head moves during printing.
[Data Width] restricts print head movement to the printed area. Restricting the
extent of print head movement increases print speed.
If [Data Width] is selected, the print head will move the full width of the
largest media supported by the printer. Select this option for more even print
results with less variation.
Choose the number of times each line is printed.
Choose [Printable Side Out] or [Printable Side In] according to how the media
is rolled.
Choose [Periodically] or [Every page] to have the printer automatically
monitor and adjust media tension during printing for optimal results, [Off] to
disable automatic tension adjustment. [Periodically] is recommended in most
circumstances. The printer may however be unable to adjust tension
appropriately for some media, resulting in excessive slack or other
maladjustments that cause printing problems, in which case you should select
[Off]. Note, however, that [Off] may result in unusually large margin between
pages. In addition, printing may not stop and the inside of the printer may
become stained. Observe the following precautions:
Do not print at the end of a roll
Do not select [Off] for [Media End Check].
Select [Every page] for more precise tensioning, but note that print times will
increase.
Increase tension if creases appear in the media during printing. The higher the
value, the greater the tension.
Choose a slower feed speed if thin media is creased or torn or sticks together
during printing. The lower the value, the slower the speed.
Prints all the contents set in the Media Setup Numbers 1 to 30.
Control Panel
Revision A
Explanation
Confidential
23