Epson SC-B7000 Series Service Manual page 20

SC-F7000 Serie/SC-B7000 Series
LCD
Display Description
1
2
3
Figure 1-10. LCD
Table 1-14. LCD
Name
Printer status, operating status, or an error message is
1 Message
displayed.
From left to right, shows the selected media number,
platen gap, media width, and media remaining.
If a media setting bank number created with this printer is
selected as the print media, the number (from 1 to 30) will
be displayed. When [RIP Settings] is selected, 0 will be
displayed.
The icon of platen gap changes depending on the setting
value as shown below.
2 Media information
The media remaining is not displayed if [Off] is selected
for [Remaining Setup] in the [Media Remaining] menu.
PRODUCT DESCRIPTION
Function
: 1.5
: 2.0
: 2.5
Name
3 Chip unit status
4
4 Waste ink bottle status
Control Panel
Table 1-14. LCD
Function
The status of the chip unit is indicated as follows.
Ready to print.
An error occurred.
The chip unit could not be recognized or it is not
compatible with the printer. Or, the slider is not
locked.
The chip unit requires replacement.
The status of the wasted ink bottle is indicated as follows.
No problem
Almost full
Full
Revision A
20
Confidential