SC-F7000 Serie/SC-B7000 Series
4.11.5 Head Inclination Manual Adjustment (CR
direction)
PAPER USED
Size: 24 inch length or longer
Type: Premium Glossy Photo Paper (250)
EXECUTION MODE
Normal Mode
PROCEDURE
1.
Turn the printer ON.
2.
Load the paper into the printer.
3.
Start the Service Program and select
direction).
4.
Click [Run]. The adjustment pattern is printed.
Figure 4-6. [Head inclination manual adjustment (CR direction)] Screen
ADJUSTMENT
Head inclination manual adjustment (CR
Head Related Checks and Adjustments
5.
Examine the printed pattern using a loupe.
If adjustment is needed, go to
Step
Paper feed
direction
Figure 4-7. Judgment
6.
Press the F11 key of the keyboard to unlock the CR unit.
7.
Move the CR unit to the left end of the printer.
8.
Remove the CR Cover.
(P. 60)
9.
Loosen the three screws (A, B, C) that secure the Damper Kit.
10. Loosen the three screws (D, E, F) that secure the Head Holder.
11. Loosen the screw (G) (Bit No. 1) that secures the Adjustment Knob.
Be careful not to completely remove the screws that secure the
C A U T I O N
Adjustment Knob.
12. Turn the Adjustment Knob to correct the head inclination.
13. Shake the Damper Kit in all directions to make the adjustment of the tilt of the
head easier.
Revision A
6.
OK
NG
NG
Misalignment within one-dot width is OK.
Confidential
110