SC-F7000 Serie/SC-B7000 Series
Damper Kit
Figure 4-8. Correcting the Head Inclination
14. Tighten the three screws to secure the Head Holder.
Tighten them in the order shown below.
D - E - F
15. Tighten the screw to secure the Adjustment Knob.
16. Tighten the three screws to secure the Damper Kit.
(there is no particular order to tighten them.)
17. Attach the CR Cover.
18. Print the pattern and see if the inclination is corrected. If not, repeat the procedure
until a normal pattern is printed.
19. When finished, click
[Finish]
and turn the printer OFF.
ADJUSTMENT
Adjustment Knob
Head Related Checks and Adjustments
For which direction to turn the knob, see below.
C H E C K
P O I N T
Paper feed
direction
When BK lines lie
above C lines,
turn clockwise
The lines move about one-dot width when the knob is moved by
seven or eight notches.
Revision A
When BK lines lie
below C lines,
turn counterclockwise
111
Confidential