Epson SC-B7000 Series Service Manual page 127

SC-F7000 Series/SC-B7000 Series
5.3.1.2 Preparation for installation (after transport)
1. Start the printer in the Serviceman Mode.
Turn on the printer while pressing [Menu] + [Back] + [OK].
2. Remove all the ink tanks. (Page 79)
3. Lower all the lock levers.
4. Start the service program and select
spec) from ADJUSTMENT (Sequence).
5. Select Ink eject.
Select All channels, and press the
(Page 116)
6. Select Switch between Ink cartridges and Ink
Select All channels and Ink Tank, and press the
tank available. (Page 114)
7. Turn off the printer.
8. Install the new ink tanks. (Page 79)
9. Install the new chip units, and pour ink.
10. Turn on the printer.
11. Discard the waste ink.
12. Reset the counter for the waste ink bottle from the control panel.
Maintenance Waste Ink Counter
13. Select Initial ink charge.
Select All channels, and press the
118)
14. Select Nozzle Check.
Select Nozzle Check Pattern Print, and press the
check. (Page 109)
15. Perform cleaning if necessary. (Page 109)
MAINTENANCE
Procedure (After no using printer over
[Run] button to run the cleaning liquid eject.
tanks.
[Run] button to make the ink
[OK]
[Run] button to run the initial ink charge.
[Run] button to run the nozzle
When left unused/transportation
(Page
Revision A
127
Confidential