Epson SC-B7000 Series Service Manual page 72

SC-F7000 Serie/SC-B7000 Series
10. Remove the three screws that secure the Pump Cap Unit.
B) Silver M4x8 S-tite screw with built-in washer: 3 pcs
11. Pull the Pump Cap Unit frontward to disengage the hook, and remove the Pump
Cap Unit avoiding contact with the CR shaft or any other parts.
12. Pull out the Waste Ink Tube from the Pump Cap Unit.
Install the Pump Cap Unit while aligning its screw head with
the hole on the frame. If they do not match, the current
attachment position is wrong.
Align the hook on the Pump Cap Unit with the hole on the
frame shown in the figure below.
DISASSEMBLY & ASSEMBLY
Screw head
Hook
Hole
Hole
Disassembly and Assembly Procedure
Waste Ink Tube
B
B
Hook
Figure 3-29. Removing the Pump Cap Unit
Revision A
Pump Cap Unit
B
72
Confidential