SC-F7000 Serie/SC-B7000 Series
6.
Move the CR Unit to the left end, and remove the CR Cover.
7.
Loosen the screws that secure the PG adjustment levers on the left and the right.
8.
Move the PG adjustment levers up and down to change the gap (PG).
9.
Tighten the screws to secure the PG adjustment levers, and go back to
repeat the procedure until the height of the CR Unit falls within the standard range.
PG Adjustment Levers
Raise the lever to move the CR up
Lower the lever to move the CR down
Figure 4-5. PG Adjustment Levers
ADJUSTMENT
(P. 60)
Step
Fixing screws
CR Related Adjustments
4, and
Revision A
108
Confidential