Initial Ink Charge - Epson SC-B7000 Series Service Manual

SC-F7000 Serie/SC-B7000 Series

4.12.5 Initial Ink Charge

Due to the structure of this printer, you cannot replace only one
C H E C K
P O I N T
tank. Therefore, replacement of the tanks should be made
according to the combinations below.
For SC-F7000 Series
BK and M
•
Y and C
•
For SC-B7000 Series
• BK and Y
M and C
•
EXECUTION MODE
Serviceman Mode
PROCEDURE
When using cleaning cartridges or ink cartridges for service (such as when
replacing the ink tube or ink holder)
1. Activate the cartridges. (P. 115)
2. Remove the ink tank. (P. 79)
3. Install the cartridges. (P. 79)
4. Turn the printer ON in the Serviceman Mode.
Turn the power ON while pressing [Menu] + [Back] + [OK].
5. Start the Service Program and select
6. Select the colors to fill (All channels
button to start the initial ink charge.
7. When finished, click [Finish].
8. Turn off the printer.
9. Activate the ink tanks. (P. 114)
10. Remove the cartridges. (P. 79)
11. Install the ink tanks. (P. 79)
ADJUSTMENT
Initial ink charge.
or Single channel), and click the [Run]
Ink Supply Related Checks and Adjustments
12. Turn on the printer.
13. Confirm that there are no errors.
When replacing old ink tanks with new ones (such as due to wrong ink mixture
error, ink clogging, transportation, or when leaving the printer unused or when the
end of ink tank's life is reached.)
1. Turn the printer ON in the Serviceman Mode.
Turn the power ON while pressing [Menu] + [Back] + [OK].
2. Start the Service Program and select
3. Install the chip unit for the colors to fill, and pour ink.
4. Select the colors to fill (All channels
button to start the initial ink charge.
5. When finished, click [Finish].
6. Turn off the printer.
Figure 4-17. [Initial ink charge] Screen
Revision A
Initial ink charge.
or Single channel), and click the [Run]
Confidential
118