Epson SC-B7000 Series Service Manual page 113

SC-F7000 Serie/SC-B7000 Series
7. Move the CR unit to the left end of the printer.
8. Remove the CR Cover. (P. 60)
9. Loosen the screw (Bit No. 1) that secures the Adjustment Knob.
Be careful not to completely remove the screw that secures the
C A U T I O N
Adjustment Knob.
10. Move the Adjustment Knob to correct the head slant.
See Figure 4-12 for which direction to move the knob.
Adjustment Knob
Screw
Figure 4-11. Correcting the Head Slant
11. Tighten the screw to secure the Adjustment Knob.
12. Print the pattern and see if the slant is corrected. If not, repeat the procedure until a
normal pattern is printed.
ADJUSTMENT
13. When finished, click
Paper feed direction
Head Related Checks and Adjustments
[Finish] and turn the printer OFF.
Rear Front
Condition of the head
Printed pattern
Rear Front
Adjustment knob
Print Head
Figure 4-12. Adjustment
Revision A
Rear Front
Rear Front
Print Head
113
Confidential