Epson SC-B7000 Series Service Manual page 24

SC-F7000 Serie/SC-B7000 Series
Menu
Side Margin (Right)
Side Margin (Left)
Printer Setup
Print Start Position
Media Size Check
Media End Check
Media Skew Check
PRODUCT DESCRIPTION
Menu Item/Setting Values (shaded one is the default)
3 to 25 mm
3 to 25 mm
0 to 800 mm
On
Off
On
Off
On
Off
Table 1-15. Setup Menu
Sets the side margin from the media's right end while the media is set in the
printer. The media's right end differs depending on [Media End Check]
setting in the Setup Menu as follows.
When Media End Check is On: Right end of the media
When Media End Check is Off: Right end standard position (the position up
to Platen through the center of the media set position attached on the Pre
Heater)
Sets the side margin from the media left end while the media is set in the
printer. The media left end differs depending on [Media End Check] setting in
the Setup Menu as follows.
When Media End Check is On: Left end of the media
When Media End Check is Off: The position to the left 64 inch from the right
end standard position
Make this setting for printing more to the left than the setting value of [Side
Margin (Right)]. Such as when printing near the center of the media width.
The margin is a value from the media's right end to the value set in [Print Start
Position]. When [Side Margin (Right)] is set already, the margin is the value
set in [Side Margin (Right)] plus the first value. The media's right end
depends on [Media End Check] setting in the Setup Menu as follows.
When Media End Check is On: Right end of the media
When Media End Check is Off: Right end standard position (the position up
to Platen through the center of the media set position attached on the Pre
Heater)
Selects [On] to detect the media width and the top or [Off] to set it to off.
Select [Off] and print when Media Size error is displayed even though the
media is set correctly. However, when this setting is set to [Off], the printed
data can be out of range of the media. If it happens, the ink contaminates the
inside of the printer. Setting to [On] is recommended usually.
Selects [On] to detect the media end or [Off] to set it to off. Select [Off] and
print when Media Out error is displayed even though the media is set
correctly. Setting to [On] is recommended usually.
Selects [On] to stop printing and display an error on the control panel screen
when the set media is skewed, or [Off] to continue to print. The skewed media
causes media jam, so setting to [On] is recommended usually.
Control Panel
Revision A
Explanation
Confidential
24