Mounting Specifications - WEG CFW-10 EASYDRIVE User Manual

CHAPTER 3 - INSTALLATION AND CONNECTION
3.1.2 Mounting Specification
22
Figure 3.1 - Free-Spaces for Cooling
CFW-10 Model
1,6A / 200-240V
2,6A / 200-240V
4,0A / 200-240V
7,3A / 200-240V
30 mm
1,6A / 110-127V
2,6A / 110-127V
4,0A / 110-127V
Table 3.1 - Recommended free spaces
Install the inverter in vertical position.
Leave free space around the inverter as indicated in Table
3.1.
Do not install heat sensitive components immediately above
the inverter.
When inverters are installed top and bottom, maintain the
minimum recommended distance A + B and deflect the hot
air coming from the inverter below.
Install the inverter on a flat surface.
External dimensions and mounting holes are according to
Fig. 3.2.
For CFW-10 installation procedures, see Fig. 3.3.
Provide independent conduits for signal, control and power
conductors. (Refer to Electrical Installation). Separate the
motor cables from the other cables.
A B
1,18 in 50 mm 2 in
C
50 mm 2 in