General Information; About This Manual; Software Version - WEG CFW-10 EASYDRIVE User Manual

2.1 ABOUT THIS MANUAL

2.2 SOFTWARE VERSION

14

GENERAL INFORMATION

This chapter defines the contents and purposes of this manu-
al and describes the main characteristics of the CFW-10
frequency inverter. Identification, receiving inspections and
storage requirements are also provided.
This Manual is divided into 10 Chapter, providing infornation
to the user on receiving, installation, start-up and operation:
Chapter 1 - Safety Notices;
Chapter 2 - General Informations and Receiving the CFW-
10;
Chapter 3 - CFW-10 and RFI Filters - Mechanical and
Electrical Installation (power and control circuitry)
Chapter 4 - Start-up - Steps to follow
Chapter 5 - Using the Keypad (Human Machine Interface -
HMI)
Chapter 6 - Setup and Read-only Parameters - Detailed
description.
Chapter 7 - Solving problems, cleaning instructions and
preventive maintenance
Chapter 8 - CFW-10 Optional Devices - Description,
technical characteristics and installation.
Chapter 9 - CFW-10 ratings - Tables and technical
information.
Chapter 10 - CFW-10 Warranty.
This Manual provides information for the correct use of the
CFW-10. The CFW-10 is very flexible and allows the operation
in many different modes as described in this manual.
As the CFW-10 can be applied in several ways, it is impossible
to describe here all of the application possibilities. WEG does
not accept any responsibility when the CFW-10 is not used
according to this Manual.
No part of this Manual may be reproduced in any form, without
the written permission of WEG.
It is important to note the Software Version installed in the
CFW-10, since it defines the functions and the programming
parameters of the inverter.
This manual refers to the software version indicated on the
inside cover. For example, the Version 1.0X applies to versions
1.00 to 1.09, where "X" is a variable that will change due to
minor software revisions.
The Software Version can be read in the Parameter P023.
CHAPTER 2