Intermec CV41 User Manual page 74

Chapter 4 — Configure the Computer
DRAFT
60
c Enter a User Name and Subject Name.
11 Save your settings.
Configure LEAP Security With Wireless
After you configure the communications and radio parameters on
your computer and select Wireless as your security choice, you can
configure LEAP.
1 Start Intermec Settings.
2 Choose Communications > 802.11 Radio > Wireless.
3 Select the profile you want to configure.
4 For 8021x, choose LEAP.
5 For Association, choose Open, WPA, WPA2, or Network EAP.
Encryption automatically defaults to TKIP if you choose WPA,
AES if you choose WPA2, and WEP if you choose Open or
Network EAP.
6 For Prompt for Credentials, choose Enter credentials now.
7 Enter a User Name and User Password.
8 Save your settings.
Configure Static WEP Security With Wireless Security
Use the following procedure to configure static WEP security with
Wireless. Intermec recommends that you use WPA2-PSK instead of
WEP if possible.
1 Make sure the communications and radio parameters on your
computer are configured.
2 Make sure Wireless is selected as your security choice.
3 Start Intermec Settings.
4 Choose Communications > 802.11 Radio > Wireless Security.
5 Select the profile you want to configure.
6 For 8021x choose None.
7 For Association, choose Open.
CV41 Vehicle Mount Computer (Windows Embedded Standard) User Guide