Intermec CV41W Series Manual

CV41 Fixed Vehicle Mount Computer Compliance
Insert
Models CV41C, CV41W
For Users in English-Speaking Regions (en)
Caution: This marking indicates that the user should read all included documentation before use. Retain this
supplement for future reference.
The users of this product are cautioned to use accessories and peripherals approved by Intermec Technologies Corporation.
The use of accessories other than those recommended, or changes to this product that are not approved by Intermec
Technologies Corporation, may void the compliance of this product and may result in the loss of the user's authority to operate
the equipment.
Product documentation is available at www.honeywellaidc.com.
Caution: For use with Intermec Model CV41D RAM Mount Smart Dock.
Caution: For use with Totex battery pack Model OVT310L1R00 only. See battery instructions.
Battery Information
Caution: The battery pack used in this device may ignite, create a chemical burn hazard, explode, or release toxic
materials if mistreated. Do not incinerate, disassemble, or heat above 100 °C (212 °F). Do not short circuit; may
cause burns. Keep away from children.
Promptly dispose of used batteries according to the instructions.
Battery Recycling Information
This product contains or uses a lithium-ion (Li-ion) main battery. When the battery reaches the end of its useful
life, the spent battery should be disposed of by a qualified recycler or hazardous materials handler. Do not mix
this battery with the solid waste stream. Contact your Intermec Technologies Service Center for recycling or
Li-ion Li-ion
disposal information.
802.11 Radio Precaution Statement
Caution: Users are responsible for configuring the channels of operation that comply with their country regulatory
standards. A Wireless Network Administrator should review the operating restrictions detailed within the Access
Point installation manual.
Radiation Exposure Statement
Warning: This equipment complies with International Commission on Non-Ionizing Radiation Protection (ICNIRP),
IEEE C95.1, Federal Communications Commission Office of Engineering and Technology (OET) Bulletin 65, Canada
RSS-102, and European Committee for Electrotechnical Standardization (CENELEC) limits for exposure to radio
frequency (RF) radiation.
Use of antennas and accessories not authorized may void the compliance of this product and may result in RF exposures
beyond the limits established for this equipment.
When installing and using this product, a 20 cm (7.87 in) passing distance must be maintained from the body or head of the
user or nearby persons and the antenna. The antenna must not be touched during transmitter operation.
For Users in the U.S.A. and Canada
U.S.A. Digital Emissions Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Complies with
IDA Standards
DA 102905
1