About Network Communications; Configure 802.11A/B/G/N (Wi-Fi) Radio Communications - Intermec CV41 User Manual

About Network Communications

Configure 802.11a/b/g/n (Wi-Fi) Radio Communications

DRAFT
CV41 Vehicle Mount Computer (Windows Embedded Standard) User Guide
You can easily add the computer to your wireless or wired data
collection network. You can connect your computer using:
• 802.11a/b/g/n radio communications.
• Bluetooth communications.
USB and serial communications.
•
Make sure all components with antennas are at least 30 cm (1 ft)
apart when power is applied. Failure to comply could result in
equipment damage.
The computer contains an 802.11 radio to transfer data using wireless
communications and to support the TCP/IP network protocols. This
section of the manual assumes that your wireless network is set up,
including your access points.
By default, the 802.11 radio is enabled. If it is disabled, use the
following procedure to enable the Wi-Fi radio using Intermec Settings.
1 From the Intermec Settings main menu, tap Communications >
802.11 Radio > Radio Enabled.
Chapter 4 — Configure the Computer
49