Appendix C — ScanNGo Wi-Fi Configuration Bar Codes
Radio Configuration Bar Codes
2D Configuration Bar Codes
2D Imager Radio Configuration Bar Codes
When You Want To:
•
Set all communication settings to defaults
(Wi-Fi, WWAN if applicable)
•
Enable Wi-Fi - set Funk security to defaults
DRAFT
106
Use the following ScanNGo bar codes to enable the 802.11 radio and
set the defaults for either Funk security or Microsoft security. After you
scan the bar codes, you will still need to use Intermec Settings or
another configuration program to set network-specific settings on
your computer and to configure the wireless security.
Note: If you are using Microsoft security, you can only use the 1D
configuration bar codes.
The following ScanNGo bar codes were created using SmartSystems
Foundation. For more information on SmartSystems Foundation, see
"Manage the Computer Using SmartSystems Foundation" on
page
34.
You can configure the computer with a 2D imager.
1 Scan the appropriate bar code from the table and wait for the
program to start.
2 Follow any instructions on the device.
CV41 Vehicle Mount Computer (Windows Embedded Standard) User Guide
Scan This Bar Code