The Carrier Sheet Is Not Fed Smoothly. / Paper Jams Occur - Fujitsu ScanPartner SP30 Operator's Manual

Chapter 7 Troubleshooting
The Carrier Sheet is not fed smoothly. / Paper
jams occur.
Did you scan just the Carrier Sheet continuously?
No
Is the Carrier Sheet clean?
Yes
Did you start the scan after loading the Carrier Sheet in the
ADF paper chute (feeder)?
Yes
Are the glass and rollers inside the ADF clean?
Yes
Are the consumables (*1) worn out?
No
Is there any foreign matter inside the ADF?
No
Feed about 50 sheets of PPC paper (recycled paper) before scanning with the
Carrier Sheet.
Yes
The PPC paper can either be blank or printed.
Perform one of the following.
Clean the Carrier Sheet.
No
For details about cleaning, refer to
Replace the Carrier Sheet.
For information on purchasing the Carrier Sheet, contact your FUJITSU
scanner dealer or an authorized FUJITSU scanner service provider.
Start the scan after loading the Carrier Sheet in the ADF paper chute (feeder).
For details, refer to "Documents Larger than A4/Letter Size" (page 58)
No
"Scanning Photographs and Clippings" (page
Clean the inside of the ADF.
For details about cleaning, refer to
No
Check the consumable counters and replace them if necessary.
For details, refer to "Chapter 6 Replacing the Consumables" (page
Yes
Clean or remove any foreign matter from the ADF.
For details, refer to "Chapter 5 Daily Care" (page
Yes
"Chapter 5 Daily Care" (page 70).
or
60).
"Chapter 5 Daily Care" (page 70).
80).
70).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
109