Opening/Closing The Adf - Fujitsu ScanPartner SP30 Operator's Manual

Chapter 1 Scanner Overview

1.4 Opening/Closing the ADF

This section describes how to open and close the ADF.
How to Open the ADF
1
Remove all documents from the ADF paper chute
(feeder).
2
Pull the ADF release tab towards you to open the ADF.
ADF release tab
Be careful not to have your fingers caught
when the ADF closes.
How to Close the ADF
1
Close the ADF.
Push the center of the ADF until it locks in place.
Be careful not to have your fingers caught
when the ADF closes.
ATTENTION
Make sure that there is no foreign matter caught inside the ADF.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
25