Quality Of Scanned Text Or Lines Is Unsatisfactory - Fujitsu ScanPartner SP30 Operator's Manual

Chapter 7 Troubleshooting

Quality of scanned text or lines is unsatisfactory.

ADF:
Are the glass and rollers inside the ADF clean?
Flatbed (ScanPartner SP30F):
Is the document pad clean?
Yes
Is the resolution appropriate?
Yes
Did you select the scan settings that simply "binarize"
(output in black & white)?
Yes
Is there any foreign matter (e.g. dust, paper dust) on the
document?
No
*1: When scanning in grayscale or color, the scanned image may not become sharp and clear. If possible, use a scanner driver to configure the scan settings
that simply "binarize" (output in black & white), and then perform a scan.
Clean the inside of the ADF.
For details, refer to "Chapter 5 Daily Care" (page
No
Specify a higher resolution in the scanner driver.
No
In the scanner driver, select the scan settings that simply "binarize" (output in black
& white). (*1)
No
Remove any foreign matter off the document.
It may be carried onto the glass inside the ADF or the document bed of the flatbed
Yes
(ScanPartner SP30F), and cause the image to become dirty.
If the problem persists, check the items in
Service Provider" (page 112)
an authorized FUJITSU scanner service provider.
70).
"7.4 Before You Contact the Scanner
first, then contact your FUJITSU scanner dealer or
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
98