Chapter 8 Operational Settings
8.6 Settings Related to Multifeed Detection
Specifying a Multifeed Detection Method
[Multifeed]
Multifeed is an error where two or more sheets are fed through
the ADF at once. It is also called a multifeed when a different
document length is detected.
Not noticing multifeed errors while scanning may put you in a
situation where important data are missing from the scanned
images.
Multifeed detection can be used to prevent such troubles.
When this function is enabled, an error message is displayed
as soon as it detects a multifeed, and stops the scan. Note
that multifeed cannot be detected within 30 mm from the
leading edge of the document.
1
Start up the Software Operation Panel.
For details, refer to
"8.1 Starting Up the Software Operation Panel"
(page
116).
2
From the listing on the left, select [Device Setting 2]
[Multifeed].
3
Select a detection method.
Method
None
Does not detect multifeed.
Check
Detects multifeed by the overlapping of
Overlapping
documents.
(Ultrasonic)
When this is selected, you can also specify the
following options:
Specify the detection range by the length from
the top of the document.
Proceed to
"Specifying the Area to Detect
Multifeed [Document check area specification
for Multifeed Detection]" (page
Description
140).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
138