Fujitsu ScanPartner SP30 Operator's Manual page 20

Chapter 1 Scanner Overview
ScanPartner SP30F
■Front
Side guide
Guides the documents in the width direction
as they are fed into the scanner.
ADF (Automatic Document Feeder)
Pulls and feeds the documents one sheet at
a time from the ADF paper chute (feeder).
Open to replace consumables or clean the
inside of the scanner.
Stacker
Stacks up the ejected documents.
Stacker extension
Lift up to adjust to the document length.
Flatbed
For scanning documents (e.g. thin paper,
books) that cannot be scanned with the
ADF.
ADF paper chute (feeder)
Holds the documents to be scanned.
Chute extension 2
Pull out to adjust to the document length.
Chute extension 1
Pull out to adjust to the document length.
ADF release tab
Pull this tab to open the ADF.
Operator panel
Consists of buttons and indicators.
Can be used to operate the scanner or
check the status.
For details, refer to "Chapter 3 How to Use
the Operator Panel" (page 52).
Transport lock switch
Locks the carrier unit (which is inside the
flatbed) to prevent damage during
transportation.
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
20