Scanpartner Sp25/Scanpartner Sp30 - Fujitsu ScanPartner SP30 Operator's Manual

Chapter 1 Scanner Overview
1.2 Parts and Functions
This section shows the names of the scanner parts.

ScanPartner SP25/ScanPartner SP30

■Front
Side guide
Guides the documents in the width
direction as they are fed into the scanner.
ADF (Automatic Document Feeder)
Pulls and feeds the documents one sheet at
a time from the ADF paper chute (feeder).
Open to replace consumables or clean the
inside of the scanner.
Stacker
Stacks up the ejected documents.
Stacker extension 1
Slide out to adjust to the document length.
Stacker extension 2
Lift up to adjust to the document length.
Stacker extension 3
Lift up to adjust to the document length.
ADF paper chute (feeder)
Holds the documents to be scanned.
Chute extension 2
Pull out to adjust to the document length.
Chute extension 1
Pull out to adjust to the document length.
ADF release tab
Pull this tab to open the ADF.
Operator panel
Consists of buttons and indicators (LED).
Can be used to operate the scanner or
check the status.
For details, refer to "Chapter 3 How to Use
the Operator Panel" (page 52).
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
17