Fujitsu ScanPartner SP30 Operator's Manual page 77

Chapter 5 Daily Care
Ultrasonic sensor (× 2)
Gently wipe the dirt and dust off the surface of the ultrasonic sensors.
If it is difficult to clean, use a cotton swab.
Ultrasonic sensor
Feed roller (× 2)/Eject roller (× 2)
The power must be turned on to rotate the feed/eject rollers.
1 Turn on the scanner.
For details, refer to "1.3 Turning the Power ON/OFF" (page
2 When the operator panel is in ready status, open the ADF.
For details, refer to "1.4 Opening/Closing the ADF" (page
3 When you press the [Scan/Stop] button on the operator panel, the
feed/eject rollers rotate a certain amount.
Check
Scan
/Stop
[Scan/Stop] button
Power
When you press the [Scan/Stop] button,
the feed/eject rollers rotate at the same
time. Be careful not to touch the rollers
with your hand while they are rotating.
4 Put a piece of cloth moistened with Cleaner F1 or a sheet of
Cleaning Wipe against the roller surface, and wipe horizontally.
Wipe the whole surface by pressing the [Scan/Stop] button to
rotate the rollers.
Make sure that it is cleaned properly because residue on the roller
will affect the feeding performance.
As a guideline, pressing the [Scan/Stop] button seven times will
rotate the feed/eject rollers one revolution.
TOP
Contents
Index
Introduction
24).
Scanner
25).
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
77