Replacing The Pick Roller - Fujitsu ScanPartner SP30 Operator's Manual

Chapter 6 Replacing the Consumables

6.3 Replacing the Pick Roller

Replace the pick roller in following procedure.
1
Remove all documents from the ADF paper chute
(feeder).
2
Remove the ADF paper chute (feeder).
Hold both ends of the ADF paper chute (feeder), and lift
2
out in the direction of the arrow.
1
3
Open the ADF.
For details, refer to "1.4 Opening/Closing the ADF" (page
Be careful not to have your fingers caught
when the ADF closes.
1
then pull it
2
ADF paper chute
(feeder)
25).
4
Remove the pick roller.
1 Open the sheet guide by lifting the tab.
2 Rotate the bushing on the shaft.
Tab
Sheet guide
Bushing
Shaft
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
84