Fujitsu ScanPartner SP30 Operator's Manual page 44

Chapter 2 How to Load Documents
ATTENTION
When you scan plastic cards, take note of the following.
- Up to three plastic cards can be loaded in the ADF paper chute
(feeder).
Note that you can only load one card at a time if the plastic card is
embossed.
- It is recommended to place the card face-down in the ADF paper
chute (feeder).
- Cards should be within the following specifications:
ISO7810 ID-1 type compliant
Size : 85.6 × 53.98 mm
Thickness : 1.4 mm or less
Material : PVC (polyvinyl chloride) or PVCA (polyvinyl chloride
acetate)
Make sure to check if the card can be scanned first.
- Rigid cards may not be fed properly.
- If the surface of the card is dirty with grease marks (e.g.
fingerprints) and such, perform scanning after wiping the dirt off.
- Scanning thick documents such as plastic cards will be falsely
detected as multifeed.
In that case, disable multifeed detection.
HINT
When scanning semi-transparent documents, increase the
brightness for scanning to avoid bleed-through.
When you scan documents written in lead pencil, make sure to clean
the rollers frequently. Otherwise, the rollers will be contaminated
which may leave black traces on the document or cause feeding
errors.
For details about cleaning, refer to
If multifeeds, pick errors or paper jams occur frequently, refer to
Troubleshooting" (page 94).
When you scan documents with the ADF, all documents must be flat
on the leading edge. Make sure that curls on the leading edge of the
documents are kept within the following range.
30 mm or more
(1.18 in.)
Feeding direction
3 mm
5 mm
or less
or less
(0.12 in.) (0.20 in.)
Leading edge
Scanned side
"Chapter 5 Daily Care" (page 70).
"7.3
30 mm or more
(1.18 in.)
Feeding direction
Leading edge
Scanned side
TOP
Contents
Index
Introduction
Scanner
Overview
How to Load
Documents
How to Use the
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
44