Scanned Images Turn Out Elongated - Fujitsu ScanPartner SP30 Operator's Manual

Chapter 7 Troubleshooting

Scanned images turn out elongated.

Are the rollers clean?
Yes
Do the documents meet the requirements described in
"Precautions" in "Conditions" (page
Yes
(*1)
Are the consumables worn out?
No
Have you adjusted the offset/vertical magnification?
Yes
*1: "Consumables" refers to the brake roller and the pick roller.
Clean the rollers.
For details, refer to
No
Use documents that meet the requirements.
42)? For details, refer to
No
Check the consumable counters and replace them if necessary.
For details, refer to
Yes
In [Device Setting] of the Software Operation Panel, adjust the offset in feed
direction (vertical magnification).
No
For details, refer to
magnification Adjustment]" (page
If the problem persists, check the items in
Service Provider" (page 112)
an authorized FUJITSU scanner service provider.
"Chapter 5 Daily Care" (page 70).
"2.3 Documents for Scanning" (page
"Chapter 6 Replacing the Consumables" (page
"Adjusting the Position to Start the Scan [Offset/Vertical
132).
"7.4 Before You Contact the Scanner
first, then contact your FUJITSU scanner dealer or
Contents
Introduction
Scanner
Overview
42).
How to Load
Documents
How to Use the
80).
Operator Panel
Various Ways to
Scan
Daily Care
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
TOP
Index
106