Fujitsu ScanPartner SP30 Operator's Manual page 125

Chapter 8 Operational Settings
Item
Count Check the counters to determine when to replace
(page 129) the consumables.
Also use it to reset the counters after replacing
the consumables.
Power saving Specify the waiting time before entering power
(page 144) saving mode.
Power off after a certain period of time: Select to
set the scanner to turn the power off
automatically if the scanner is left on for a certain
period of time without being used.
Specify the timeout period for the scanner to be
automatically turned off.
Offset Setting Adjust the position to start the scan on the
(page 132) selected scanning side(s).
Vertical Adjust the magnification level in feed direction for
magnification the selected scanning method.
Adjustment
(page 132)
Description
Total Count (ADF)/Total Count(FB) (ScanPartner SP30F) /
Brake Roller/Pick Roller
Range: 5 to 235 min. (in increments of 5)
[Power off after a certain period of time] check box
1 Hour/2 Hours/4 Hours/8 Hours
(When the [Power off after a certain period of time] check box
is selected)
Unit: Flatbed (ScanPartner SP30F)/ADF(front)/ADF(back)
Main/Sub: -2 to 2mm
(in increments of 0.5mm)
Unit: Flatbed (ScanPartner SP30F)/ADF
Range: -3.1 to 3.1% (in increments of 0.1)
Parameter/Value
TOP
Contents
Index
Factory Default
Introduction
0
Scanner
Overview
15 min.
How to Load
Documents
Selected
How to Use the
4 Hours
Operator Panel
Various Ways to
Scan
Main/Sub: 0 mm
Daily Care
0%
Replacing the
Consumables
Troubleshooting
Operational
Settings
Appendix
Glossary
125