Analog Devices EVAL-ADF7023DBxZ Manual page 33

Configuring the Transmitter board for the PER test
1. Once all of the Transmitter and packet parameters are setup correctly (as in
then select the "PER" Tab.
2. Select the "Tx Board Setup" Tab
3. Set the number of packets to be received, "No. of Packets to Tx"
(Note: Ensure the number of packets on the Receive and Transmit side are set the same.)
4. Set the delay between each transmitted packet from the "Delay Between Packets" dropdown menu.
(Figure 40 point (4))
5. Write these settings to the uC by clicking "Write Tx Settings"
6. To begin the test and put the receiver into Tx click "Begin PER Tx"
(Note: The transmitter will continuously transmit packets until "No. of Packets to Tx" value is reached.)
7. If at any time you wish to terminate the test manually press "Stop Test".
(Note: The test will stop automatically once the transmitter has transmitted the final packet.)
(Figure 40 point (1))
(Figure 40 point (2))
Figure 40
R e v 1 . 1 | Page 33
Tx Setup in Packet Mode section)
(Figure 40 point (3))
(Figure 40 point (5))
(Figure 40 point (5))
(Figure 40 point (6))