Table of Contents
Advertisement
4-17 SHAFT DRIVE
FINAL ASSEMBLY
After both gear backlash and tooth
contact are
correct, remove
the secondary drive
gear
housing
and mondary driven gear housing from the
crankcase.
Clean off
any
machinist3 dye or paste from the
gear teeth,
and lubricate the teeth with Hypoid
gear
oil.
Install new O-rings on the secondary drive and
driven gear housings. Lightly grease
the O-rings.
Install the secondary drive and driven gear
housings into the upper crankcase.
-
NOTE:
Secondary drive and driven gear housings
must
be installed with the
letters
"UP"
facing
upward, as shown in Fig. @
and
@ I
(page
4-15}.
Use THREAD LOCK "1363C"
on the threads
of the housing bolts, and torque to specification.
991 04
-
32050
Thread Lock "1363C"
Reinstall secondary
gear
'box oil drain plug
and
torque
t o
specification.
Tightening
torque
Drain plug torque
!
2.0
-
3.0
kg-rn
1
(14.5
-
21.5 lb-fr)
2.0
-
2.6
kg-rn
(14.5
-
19.0 Ib-ft)
@
Fill the gear
cavity to
specified capacity, 340
-
400
ml with Hypoid gear oil.
Remount engine assernbl
y ,
see
page
3-7.
Reinstall secondary drive gear ov
ter cover.
Advertisement
Table of Contents
