Suzuki GS1100G 1982 Service Manual page 109

NOTE:
Just before placing the camshaft on the cy-
linder head, apply SUZUKl Moly Paste to its
journals, fully coating each journal
@
with
the paste taking care not
to
leave any dry
spot. Apply engine oil
to the
journal bearings.
-
-
*
With "T" mark accurately Fined up
with the
timing mark, hold the crankshaft steady and
lightly pull up the chain to remove the slack
between the crank sprocket and exhaust sprock-
et.
Exhaust sprocket bears an arrow marked "1"
indicated as
8
.
Turn over the exhaust camshaft
so that the arrow points flush with the gasket
surface of the cylinder head. Engage the timing
chain with this sprocket.
The other arrow marked
"2" is
now pointing
straight upward. Count the chain roller pins
toward the intake camshaft, starting from the
roller pin directly above this arrow marked
"2"
and ending with the 20th roller pin. Engage
the chain with intake sprocket, locating the
20th pin
a t
and above the arrow marked
"3"
on the intake sprocket.
99000 - 25140
NOTE:
The timing
chain is now riding on all three
sprockets. Be careful not to disturb the
crankshaft until the four holders and chain
tensioner adjuster are secured.
SUZUKl Moly Paste