Table of Contents
Advertisement
3-61 SERVICING ENGINE
m
Install the signal
generator rotor.
*
Make sure to fit
the slot
@
on
the back surface
of the rotor over the locating
pin
@
a t the
end
of crankshaft.
Tighten the rotor center bolt with specified
torque.
Route the signal generator lead wire
as
shown.
Tightening torque
Mount
the piston ring in the order of oil ring,
2nd ring, and top ring.
m Top
ring and 2nd (middle) ring differ in the
shape
of ring face,
and the face
o f top
ring is
chrome-plated whereas that of 2nd ring is
not.
The color of 2nd ring
appears darker than that
of the top
one.
2.5
-
3.5
kg-m
(18.0
-
25.5 Ib-ft)
Top and 2nd (middle) rings have letter "N"
marked on the side. Be sure to bring the marked
side t o top when fiBing them to the piston.
Advertisement
Table of Contents
