Audio Downmixer Settings - AMX N2412A Instruction Manual

TABLE 26
Option
Model
Serial
MAC Address
Firmware Version
Web Version
Factory Restore
Reboot

Audio Downmixer Settings

The section of the Settings page shown in
described in
Audio Downmixer Settings
FIG. 51
TABLE 28
Option
Enable HDMI Downmix
Center Gain slider
Front Gain slider
Surround Gain slider
Line out source
Cancel
Save
Defaults
N2412A/N2422A User Manual
Settings Page: Software Section
Description
Displays the model number of the N2400 Decoder.
Displays the serial number of the N2400 Decoder.
Displays the MAC address of the network interface of the N2400 Decoder.
Displays the date code for the currently running version of the N2400 Decoder internal firmware.
Displays the date code for the currently running version of the web interface.
Click to restore the device to the original factory settings. This resets everything except the IP address
(including name, stream number, serial settings, etc.).
Click to begin a software reboot. This command does not initiate a full power cycle and does not affect the
current configuration.
Table 28.
Settings Page: Audio Downmixer Settings
Description
Set HDMI audio downmixing to be disabled, enabled, or selected automatically when receiving a 7.1 audio
source.
Set percentage of audio on center channel mixed into left and right output when downmixing.
Set percentage of audio on front left and right channels mixed into left and right output (respectively).
Set percentage of audio on surround when downmixing left and right channels mixed into left and right output
(respectively).
Select a line out source or select Downmix when using the downmixer.
Click to return all controls to the last saved configuration.
Click to accept changes made to these controls.
Click to return all controls to their default settings.
Figure 51 is displayed when you click the Audio Downmixer Settings link. Options are
Decoder Configuration Options
54