Switching And Scaling Options; Seamless Switching - AMX N2412A Instruction Manual

N2400 series. encoder/decoder digital media distribution & switching solution

Table of Contents

Switching and Scaling Options

N-Series Encoders and Decoders make up a true AV matrix solution. In other words, one input can go to any or all outputs.

Decoders have internal scaling capabilities. Keep the following in mind:

The input of an Encoder is the video and/or audio signal going into the Encoder.



The output of an Encoder is the network stream.



The input of a Decoder is the network stream.



The output of a Decoder is the digital video and/or audio being transmitted out to the display device.



Upscaling and downscaling are fully supported.



The N2400 Series supports seamless switching capability if the scalers in the Decoders are enabled. If the scalers are off, all of the

sources must have the same resolution and refresh rate of the Encoder.

To get streams onto a Decoder, use the Video Matrix tab to route video from an Encoder to a Decoder. This works seamlessly if the

previously mentioned settings are true. All you have to do is click the common cell on the matrix, and click the Take button. See

Figure 16

for an example.

Enabling this cell causes the Decoder named Conf Rm Dec to listen

to the Encoder named Conference Rm Encoder.

Seamless Switching Using the Video Matrix

FIG. 16

N2412A/N2422A User Manual

Installing and Configuring Your AV Equipment

Click Take to apply

changes.

Table of Contents

N2422a