Network Setup Section; Status Section - AMX N2412A Instruction Manual

Network Setup Section

The Network Setup section of the Settings page is shown in
Network Setup Section
FIG. 46
TABLE 23
Option
IP Mode
IP address
Netmask
Gateway address
Ping Test
Trial Save

Status Section

The Status section of the Settings page is shown in
Status Section
FIG. 47
N2412A/N2422A User Manual
Settings Page: Network Setup Settings
Description
Configure the IP address mode. When set to AUTO IP,
an IP Address in the range of 169.254.xxx.xxx with
Netmask of 255.255.0.0 and Gateway address of
169.254.1.1 will be automatically assigned to the
N2400 Decoder by the control software. When set to
DHCP, an IP Address in the range of the DHCP server on
the network will be automatically assigned to the
N2400 Decoder. When set to STATIC, an IP address,
Netmask, and Gateway address must be manually
entered.
View the current IP address of the N2400 Decoder.
When in STATIC mode, enter a new IP address into this
field.
View the current Netmask of the N2400 Decoder. When
in STATIC mode, enter a new Netmask into this field.
View the current Gateway address of the N2400
Decoder. When in STATIC mode, enter a new Gateway
address into this field.
Test the connection by specifying an IP address or URL
to ping. Click the Ping link to initiate the test.
Click to initially save IP address changes. Once you log
in to the unit using the new address, you will be able to
confirm and accept the changes permanently.
Figure 46. Options are described in
Notes
DHCP is the default setting. However, using DHCP
beyond initial setup is generally not recommended. If
the device is set to DHCP and fails to receive an
address from the DHCP server in time, it will revert
back to the AUTO IP address (169.254.xxx.xxx) until
the unit is rebooted.
Figure 47. Options are described in
Decoder Configuration Options
Table 23.
Table 24.
51